BMW 29CC: Combustion misfires detected in multiple cylinders — Diagnosis and Repair
29CC means Combustion misfires detected in multiple cylinders. Learn its symptoms, causes from low to high cost, and a safe evidence-based diagnostic order.
— Tekin Code
29CC is a BMW-specific DTC stored by the DME for the combustion and multiple-cylinder misfire. Verify the complete module text because details can vary by chassis and software level.
What Does 29CC Mean?
This record reports Combustion misfires detected in multiple cylinders. It does not identify a failed part by itself; assess status, frequency, companion codes and freeze frame together.
Code: 29CC
Definition: Combustion misfires detected in multiple cylinders
Module: DME
System: combustion and multiple-cylinder misfire
Key data: status, frequency, freeze frame and companion DTCs
Typical cause: worn plugs, weak coils or loose connectors
Severity: high
Note: verify for VIN, engine and software level
The fastest OBDThink split is to see whether the code is currently active and which module records appeared at the same time.
Symptoms
• A warning or temporary loss of the related function may occur.
• The fault can be intermittent, and some vehicles show no obvious driver symptom.
• Companion DTCs may identify the root cause more clearly than this record.
Possible Causes
Work from inexpensive, easy checks toward complex causes; do not replace a part without evidence.
• worn plugs, weak coils or loose connectors
• a shared intake leak, PCV problem or low fuel pressure
• an injector, timing, VANOS or compression problem
Diagnostic Steps with OBDThink
OBDThink is an independent BMW coding and diagnostic mobile app and is not affiliated with BMW AG. On supported vehicles, use module scans, freeze frame and live data to gather evidence.
• 1. Scan every module; save the 29CC status, frequency, source module and freeze frame.
• 2. Check battery voltage and visually inspect relevant fuses, grounds, connectors and wiring.
• 3. Compare commanded and actual live values, and assess companion DTCs first.
• 4. Complete physical tests with the BMW test plan valid for the vehicle and engine; avoid guess-based replacement.
• 5. After repair, clear codes, complete the appropriate drive cycle and rescan every module.
Is the code active?
YES → Supply and basic physical checks → Live data → Component test
NO → Save records → Clear code → Verify under similar conditions
If it returns → Follow the vehicle-specific BMW test plan
The fastest OBDThink split is to see whether the code is currently active and which module records appeared at the same time.
Repair
• Low cost: correct a loose connection, contaminated connector, hose or supply issue.
• Medium cost: repair or replace a sensor, valve or peripheral unit only after testing confirms it.
• High cost: proceed to a controller, pump or major mechanical repair only when the test plan proves the need.
A successful repair means the code does not return, the warning is gone and relevant actual values behave normally. Save the final scan.
Can You Drive with This Code?
If there is power loss, severe shaking, limp mode or a fuel smell, avoid loading the engine and stop safely for diagnosis.
29CC is a diagnostic starting point; the correct repair removes the measured cause rather than merely clearing the code.